3HP Waterway Executive 230v 2-Speed 56 Frame Spa Pump 3721221-1D

Waterway Executive brand name pump by Waterway Plastics 3HP replacement spa pump 3721221-1D.

This is the original motor and wet end. 

• 56 Frame Executive Wet End
• 56 Frame Executive Motor
• 2" Intake for improved flow
• High Speed Amps:  10 amps
• Low Speed Amps:  3.4 amps
• Wet End can be rotated
• Viton Shaft Seals
• 160 gallons per minute flow rate
• Volute fastened with 8 screws.
• 2-Speed Motor
• 3 Horsepower
• 230 Volts
• 60hz for North America
• 2" connections suction and discharge (3 1/16" outer diameter measurement - 2 inch nominal)
• Side Discharge
• Length: 15.25"  Motor height: 6.45"

Pump cords sold separately if needed (AMP or JJ) but most of the time, the existing pump cord can be used if it is in good condition.

That one already has the right plug on it to match up and plug directly into the spa control system, circuit board or pack.

This brand name dual speed motor has double-shielded ball bearings with moisture-resistant grease for quieter operation and longer life too. A split capacitor (start and run) uses less energy.

Note this -2 deluxe version of this brand name Waterway Executive pump comes with full factory warranty and includes FREE O-rings so you don't end up with a leak when you go to change out your pump.

WWP3721221-1D replaces 1-P230E52024 , 1404036 , 301910 , 3721221 , 3M21221 , 404036 , 5039-306 , WW37212211D , WWP-10-1454 .