Maax Spa Control System Retrofit Kit 110237 BP501T6

Maax Spa control system retrofit kit 110237 is a wifi capable BP501T6 type spa controller now shipping with latest model controller MXBP20.

Works with up to 2 pumps and a blower - but not with a dedicated 24 hour circ pump - see circ pump system option if needed 110339.

Comes with American Whirlpool 5 and 6 button overlays.  Apply the one that is needed for your particular equipment layout.

• 110237 MXBP501/MXBP20 pack with TP600 topside // Will support up to two pumps (2 speeds) and a blower; will not support a dedicated 24 hour circ pump .

This is the original replacement pack with full factory warranty, not a cobbled together aftermarket system.

Includes 109242 topside control panel with measurements: W=7.1" (18.03cm) , H=3.5" (8.89cm). 
Use with 5 or 6 button overlays both included for 1 or 2 pump systems.

Spa pack includes case, circuit board with wiring, heater, topside control panel (oval) and a set of 2 graphic overlays.

Includes Balboa's patented overheat Fault Detection for runaway pumps or stuck relays. The new M7 Plus software design incorporates patented technology using a microprocessor to intelligently monitor the hot tub water temperature and detect a runaway pump or stuck relays. If detected, the system will automatically attempt to shut the power off to the tub to prevent any overheating by trying to trip the GFCI in the circuit (per electrical codes). (BP501 only).

Wifi ready.  Add the 50350 for wifi access to this pack.  This brings your spa into the 21st Century! 

Secure the wifi module to the spa and plug it into this wifi ready spa pack. Connect the wifi cable to the splitter cable located at J33 on the circuit board.  Download APP and enjoy!

Special order item - please allow 7-10 days for shipment.

New overlays are American Whirlpool style with same button locations that replace California Cooperage branded overlays.

Both come with this kit.
This one is for 2 pump systems without a blower.

Use this overlay for spas with 2 pumps and a blower.  Both of these new style overlays are included with the spa pack.

Replace that old pre-2006 metal spa pack with this updated spa control system.

For select spas, you may need an ABS bezel for the control panel - see 110573.  This can further be trimmed as needed to fit.

 We also offer other spa control systems depending on equipment setup:

• 110239 MXBP501/MXBP20 pack with TP800 topside // Topside is a user friendly // Will support up to two pumps (2 speeds on each) and blower; will not support a circ pump
• 110339 MXBP20 pack kit with TP800 topside // Topside is user friendly // Will support up to 3 pumps, a blower, and a circ pump and includes the larger 800 panel.

Equipment Cords sold separately as needed:

21087   5 ft 2-speed pump cord

21086  1-speed, 3 wire pump cord or blower cord