Ultra Pure Ozone Generator UPS 350 120v 60hz 1006520

Ultra Pure Ozone Generator 1006520 UPS 350, 120v/60hz, 4-pin amp cord

Ozone is the best oxidizer for the spa water.

This 4 pin AMP plug uses 3 wires - green, white, black in most Balboa spa pack applications.  AMP cord included.

(flat side down) - 120V/60hz

Ultrapure Oxidizer® Chemical Reduction System®
For portable and inground spas. Ozone generators are individually packaged and include a 1/4" x 1/4" ozone check valve, 6ft of 1/4"id pvc tubing,1/4B x 1/4B adapter, and mounting hardware

Small amounts of after-use chlorine or bromine sanitizer are still needed.

It is recommended to run the ozonator 4 - 8 hours/day, during the filter cycles.
Adjust pH level and maintain between 7.2 - 7.8 as recommended by your spa manufacturer. 
This water care method ensures that all three hot tub water sanitation requirements of Disinfection, Oxidation and Residual are met.

90 - 95% of the 'Sanitation-Workload' is the removal of non-living bather wastes, which are introduced in high quantities due to the Spa's small volume of 'above-body-temperature' hot water.

Install in ozone-ready spas:

Locate the end of the factory installed Ozone ready tubing under the spa cabinet. Insert the 1/4” Check Valve into the factory installed tubing coming from the spa noting the directional arrow on this little check valve that is the last line of defense against water backing up into the ozonator. Attach the other end of the check valve to the spa’s Ozone tubing. Attach the remaining end of the 1/4” Ozone tubing to the barbed fitting on your UltraPure™ ozonator.

For spas that are not ozone ready and do not have an existing ozonator built-in, it is possible to inject ozone into the water by using an ozone venturi (sold separately) if needed.